Flame Patio Heater OP3616
Item number:OP3616 Pyramid Heater ANSI STD Z21.97-2014 Certified to CSA STD 2.
WARNING This product can expose you to chemicals including carbon monoxide which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
(Top: 32 in Side: 26 in)
-6-
1.Attach wheels (10) to bottom plate (1) . 2.Locate the propane cylinder bracket (11) and attach it on the bottom plate with 3 bolts and nuts provided with the bracket.Use the M8x45 screw to secure the propane cylinder. 19 19 3.Connect and fix the 4 lower support (6) to the bottom plate(1) and middle plate (3) with screws (19). 4.Connect 4 upper supports (5) to the lower supports (6) with screw (19),then fix the upper plate (4) with screws (19).
3 19 5.Unscrew the red igniter button on the control box and insert the AA battery (17) with the POSITIVE end facing upward.Then attach the control box (2) underneath the middle plate (3) with screws (19). 6.Carefully put the glass tube (7) up through the center of the hole in the upper plate (4).Make sure the rubber ring (18) is attached on the lower end of the glass tube. Now place the glass tube through the hole on the middle plate (3).
19 7.Attach the reflector (8) onto the upper plate (4) and fix with screws (19). 8.Attach the protection guards (9) to the upper frame by inserting the hooks at the top of the guards into the holes on the supports. Repeat at the bottom of the supports. Secure the protection guards to the top of the supports with the fixing brackets(12) and screw in place. 19 9.Fix the sides panels (13) with the screws (19). Note:Do not cover the side where the control knob is.
10.Screw the handle (15) on the front panel (14) - attach the panel by inserting its two hooks into the holes on the bottom plate.Hook the chain (16) to the hole in the control box,then close the panel to the middle plate - the panel is attached by the magnets. Tips:the chain can hole the panel while operating the control.
HI Press the Red igniter button. 3. Check for the pilot flame through the glass tube. If the pilot does not light, press and turn the OFF LO OFF Then depress the Control Knob and turn clockwise to OFF Position. Close the valve on your LPG cylinder when the heater is not in use.
AA battery is missing or dead Replace AA battery