Use and Care Manual

04 05
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
This appliance is intended to be used in household and similar
applications such as
· Staff kitchen areas in shops,offices and other working
environments;
· Farm houses and by clients in hotels,motels and other residential
type environments;
· Bed and breakfast type environments;
· Catering and similar non-retail applications
1. Exterior Drain Plug
2. Temperature Control
3. Compressor On Indicator
4. Power on Indicator
5. Vinyl-Coated Steel Wire Removable Storage Basket
Parts And Features
Installing Your Freezer
Unpacking Your Freezer
1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the freezer accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the freezer.
Adjusting Your Freezer
· Your freezer is designed for freestanding installation only. It
should not be recessed or built-in.
· Place the freezer on a floor strong enough to support it full
loaded.
· When moving the freezer, never tilt it more than a 45-degree
angle.This could damage the compressor and the sealed system.
· If the freezer is tilted, let it stand in an upright position for at
least 24hours prior to plugging. This is to allow the refrigerant to
settle.
Proper Air Circulation
· To assure your freezer works at the maximum efficiency it was
designed for, you should install it in a location where there is
proper air circulation, plumbing and electrical connections.
The following are recommended clearances around the freezer:
Sides..........4"(102mm)
Back.....4" (102mm)
Top.........Do not block
WARNING: ELECTRICAL REQUIREMENT-SHOCK HAZARD
Electrical Requirement
· Make sure there is a suitable power Outlet (115 volts,15 amps
outlet) with proper grounding to power the freezer.