Use and Care Manual

www.costway.com
Contact Us!
Hardware inside
Do NOT return this item.
Contact our friendly customer service department for help first.
E-mail
US: [e-mail]
UK: [e-mail]
Before You Start
Read each step carefully before starting. It is very important to ensure each step followed in
correct order, otherwise assembly difficulties may occur.
Most of board parts are labeled or stamped on the raw edges. Have a check to make sure all
parts are included.
Work in a spacious area, preferably on a carpet close to where the unit will be used.
Keep the handtools close at hand. Do not use power tools to assemble your furniture.
They may scratch or damage the parts.
www.costway.com
A
C
4PCS
1PC
B
1PC
D
4PCS
E
4PCS
F
4PCS
G
1PC
A
C
E
D
F
G
B
02 03
2
8
8
8
8
2
2
S
S
S
1. There are plastic male tab and black plastic
washer on the screw of the chair back for screw
hole's protection and reinforcement.
Take off the plastic male tab first but keep the
plastic washer before assembly.
2. During the assembly, the screws with spring
washers and plastic gaskets should be screwed
into the holes that connected the iron sheet on
the stool leg. The plastic washers should be
sandwiched between the screw and the
connecting holes that strengthen connection,
increase stability and prevent screw from loosen.
3. Do not only tighten one screw! If you want to
have the legs and the bottom of the stool
assembled together, you should wait until all the
screw holes are screwed in, and then tighten
each screw completely.