Use and Care Manual
6
2. Place heater on a flat and stable surface. Setting the heater on an incline or decline may cause
damage to the unit and create a hazardous situation.
OPERATING INSTRUCTIONS____ _______........
To operate, connect to a properly polarized outlet only. Ensure the unit is in the OFF position.
Match wide blade of plug to wide slot and fully insert. Be sure to plug into a 120V AC, 60Hz
outlet.
NOTE1:
When the heater is plugged in, the power indicator will be illuminated until it is turned
off and unplugged.
NOTE2:
THE HEATER WILL NOT OPERATE UNLESS IT IS PROPERLY PLUGGED INTO A
POLARIZED OUTLET AND POWERED ON.
NOTE3:
IT WILL NORMALLY REQUIRE APPROXIMATELY 15 MINUTES FOR THE
HEATER TO REACH ITS OPERATING TEMPERATURE.
YOUR HEATER IS EQUIPPED WITH 3-CONTROL SETTINGS AND THERMOSTAT.
Thermostat Control :
This heater is equipped with a thermostat function to control
the temperature output. To increase the heat output, turn the dial clockwise. To reduce the heat
output, turn the dial counter-clockwise.
Press the both power switches down at I and II for fast warm-up of a room and turn the thermostat to
maximum ( ). Once the room is comfortable, slowly rotate the thermostat counterclockwise until
Heat Setting Control:
Pressing Left
Switch to:
Pressing Right
Switch to:
Combination Results
O O
Unit and power light is OFF
No heat is produced.
I
O
Unit and power light is ON,
Heater is on LOW setting.
O
II
Unit and power light is ON,
Heater is on MEDIUM
setting.
I
II
Unit and power light is ON,
Heater is on HIGH setting.