Model：EP22913 WARM TIPS :This product is recommended for use in 108-162 square feet of the room.
TABLE OF CONTENTS________________ IMPORTANT INSTRUCTIONS.......................................................... SAFETY SYMBOLS............................................................................. UNPACKING........................................................................................ PARTS DESCRIPTION........................................................................ ASSEMBLY........................................................................................
14. Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or the like. Arrange the cord away from traffic areas and where it will not be tripped over. 15. Do not use on soft surfaces, like a bed, where openings may became blocked. Do not place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. 16.
SAFETY SYMBOLS__________________________ UNPACKING__ _________________________ Check immediately whether all parts and accessories are present in the box. If anything is missing or broken, contact our Customer Service at 1-866-206-0888.
PARTS DESCRIPTION 1. ...... ......... ....................... Oil fins (x7) 2. Carry handle 3. Thermostat control 4. Power & setting control 5. Front panel 6. Power cord housing 7. Rolling casters ASSEMBLY....................................................... Assembly Instructions: Unpack the heater and remove all parts from the packaging. For ease of assembly, place the heater upside down or on its side on a soft surface which will not scratch the unit. Use one hand to hold it in place.
2. Place heater on a flat and stable surface. Setting the heater on an incline or decline may cause damage to the unit and create a hazardous situation. OPERATING INSTRUCTIONS____ _______........ To operate, connect to a properly polarized outlet only. Ensure the unit is in the OFF position. Match wide blade of plug to wide slot and fully insert. Be sure to plug into a 120V AC, 60Hz outlet.
the heater shuts off - you will hear a “click”. The thermostat will now maintain the temperature by cycling the heater on or off as required. Once the room is comfortable, select a lower power setting at either [I or O] or [II and O] to reduce electrical consumption and to prevent the room from becoming too warm. During particularly cold weather, the low setting at I or II power setting(s) may be insufficient to maintain the temperature set at the thermostat. Select [I and II] for these periods.
TROUBLESHOOTING................................................... If your heater fails to operate, please follow these procedures before contacting Customer service: Problem Probable Cause Solution Unplug and turn the heater off; allow it to The thermal cut-off has been activated cool for 30 minutes. Once the heater has cooled off, check to make sure that there are no objects on or adjacent to the unit. To resume operation, plug the unit back in.
PARTS LIST Please refer to the Schematic Drawing on the next page. No. DESCRIPTION Quantity No.
