Use and Care Manual

Power Button: When the machine is in the
standby mode, the display screen will be displayed
in low light LED. To start the dehumidifier, press
the power button. Concurrently, the display screen
will light up and the unit will run in Auto mode, the default
humidity setting data is 10%RH, and the machine will start if the
humidity condition meets the requirement of compressor
operation.
Press the power button again to turn off the machine, and the
fan will shut down in 1 minute later.
Add Button: Press the Add button to increase
humidity data or increase timing data .
When setting the humidity data , press the button
for one time to increase 5%RH , you can set the
humidity range from 10%-90% RH, and 5% RH for one step, it
will cycle as below :
10%-15%-20%-25%-30%-35%-40%-45%-50%-55%-60%-65%
-70%- 75%-80%-85%-90%-10% …
When setting the timing data, press the button for one time to
increase 1 hour , you can set the timing range from 1-24 hours,
and 1 hour for one step, it will cycle as below:
01-02-03-04-05…-23-24-00-01-02…
Minus Button: Press the Minus button to decrease
humidity data or decrease timing data .
When setting the humidity data , press the button
for one time to decrease 5%RH, you can set the
humidity range from 90%-10% RH, and 5% RH for one step, it
will cycle as below :
90%-85%-80%-75%-70%-65%-60%-55%-50%-45%-40%-35%
-30%- 25%-20%-15%-10%-90% …
When setting the timing data, press the button for one time to
decrease 1 hour, it will cycle as below:
24-23-22-21-20…-02-01-00-24-23…
Purge Button (Manual Drainage): Press and
hold the purge button for 3 seconds, the machine
will drain the water automatically by the built-in
pump. After 30 seconds, the pump stops draining, then the
indicator will turn off.
Timing Button: Press the timing button, the
display screen will show the current timing data,
and then press Add button to increase the
timing data or press Minus button to decrease
the timing data. Press one time to increase or decrease one hour.
The timing indicator will light up after setting. When the machine
is in the standby mode, press the timing button to set the
start-up time; when the machine is running, press it to set the
shutdown time. The timing setting range is from 0 to 24 hours. If
you set the timing data as “00”, it will cancel timing function, the
timing indicator will turn off.
OPERATION
12 13