Instructions / Assembly

14 15
Switch off the unit and remove
the air filter.
Reassemble the air filter
Rinse under a running water or using the vacuum to clean the dust.
TROUBLESHOOTING
SYMPTOM INSPECTION SOLUTION
The unit is not
operating.
There is almost
no formation of
condensate.
Excessive
Noise
Error
code
Water Leakage
Check whether the power
connection is secure.
Check whether the air
filter is dirty.
Clean the air filter as necessary.
Insert the power cord securely
into the wall outlet.
Check if the water level
indicator lights up?
Empty the water tank and
reinstall correctly.
Check the room
temperature.
Check if the air duct is
blocked.
To clear the obstacle.
This is normal. Low humidity in
low temperature environment.
Set the humidity level below
current humidity value.
Empty the water tank before
transport.
Straighten the hose to avoid a
trap existing.
Place the unit on horizontal and
firm ground.
Secure and tighten the parts.
Noise comes from flowing
refrigerant. This is normal.
To clean or replace the humidity
sensor.
Normal. The compressor stops,
and the fan keeps running.
Normal. The compressor stops,
and the fan keeps running.
Normal. The compressor stops,
and the fan keeps running.
Normal. The compressor stops,
and the fan keeps running.
Set humidity level is
higher than current
Humidity value.
Overflow while moving
the unit.
Check if the drain hose
is kinked or bends.
Check if the unit is
securely positioned.
Check if there are any
loose, vibrating parts.
Noise sounds like
water flowing.
Humidity sensor
dampened or failure.
Display when room
temperature is below
5°C（41°F）.
Display when room
temperature is above
38°C(100.4 °F).
Display when room
relative humidity is
below 20% RH.
Display when room
relative humidity is
above 90% RH.
Check if the room
temperature is below
20°C(68°F).
The range of operating temperature
is 5
O
C-38
O
C (41°F-100.4 °F).