Instructions / Assembly

MAINTENANCE
Warning!
12 13
1.Do not discard the magnets and plastic rivets in the tank. Otherwise,
the dehumidifier cannot be started, or the machine will not
automatically stop working when the water tank is full, and the
condensed water overflow will damage the floor of the room.
2.Please make sure to clean the condensed water in the water tank and
put the water tank back in place.
3.If the water tank is dirty, please rinse it with clean water. Avoid using
detergents, steel wire balls, chemical dust removers, diesel, benzene,
thinners or other solvents. Otherwise, it can damage the tank and
cause leaks.
4.Put the water tank in its original position. Otherwise, the indicator
light will always be red and the machine cannot start working again.
Continuous drainage:
1.Take out the PVC pipe and straighten the drain pipe.
2.Insert one end of the drain pipe into the drain outlet at the top of the
tank and connect the other end to the bathroom, floor drain, outdoor or
barrel container, and the area specified for drainage.
Drain pipe
1.Please do not block the drain pipe, if the blockage occurs, the
condensed water will flow into the water tank.
2.Please do not bend the drain pipe. The height of the drain pipe should
be lower than the water outlet.
The drain pipe must be firmly connected to the water outlet.
Note: Before cleaning and maintaining the machine, please be sure to
turn off the machine and unplug the power to avoid electric shock.
CLEANING THE AIR FILTER (every two weeks)
Dust collects on the filter and restricts the airflow. Restricted airflow will
reduce the efficiency of the system, and if it is blocked, it may cause
damage to the unit.
The air filter needs to be cleaned regularly. The air filter is removable for
easy cleaning. Do not operate the unit without an air filter, otherwise the
evaporator may be contaminated.
Warning!