Instructions / Assembly

5.4 DRAINAGE
Hold the child lock button to turn on or off the child lock function, the
lock indicator will turn on or off accordingly.
High speed - low speed cycle, press the button once to switch and then
the corresponding indicator light is on.
Child lock
Press this button to switch the sleep function on or off.
In "Sleep"mode, the unit operates at a low fan speed with a fixed target
humidity of 60%.
When the mode is active, the indicators for the sleep function, child lock
and power dim. All other displays go out.
Start the timer before activating the sleep function, and the dehumidifier
will turn off when the set running time is reached.
If the filter indicator lights up, the dust filter must be
checked/cleaned/replaced. Then the display can be reset by pressing and
holding (at least 3 seconds) the Sleep/Reset button.
Sleep/Reset
Speed
There are two ways to remove the collected water produced by the unit.
A.Manual draining: Manually empty the water tank.
B.Continuous draining: Use gravity to drain the condensed water by
connecting the drain hose.
5.4.1 EMPTY THE WATER TANK
The built-in device in the water tank of the unit fills the water tank
with water and shuts down the unit when the water is full. After
the water tank is emptied and installed, it will run again.
1) When the tank is full, the unit will make a buzzing sound, and the
“Water Full” light will turn on.
2) Press the POWER button to turn off the unit.
3) Pull on the water tank and simply slide out of the body of the
dehumidifier.
4) Empty the water into an area with a drain or outside.
5) Clean the inside of the tank as well as the outside.
6) Replace the empty tank back into the unit.
7) Press the POWER button to resume operating.
8) If the Water Full light does not extinguish, please check whether the
float is properly seated.
10 11
1. Pull out the water tank
2.Empty the water tank
3.Replace the empty
tank back into the unit