Use and Care Manual
NOTE:If you forgot to turn the Speed Control Dial to the “0” position when you tilt-up the Mixer Head,the
machine will not work unexpectly after you putting it down.You need to turn back to “0” and then select
any working speeds.
12. When mixing is complete,turn the Speed Control Dial to the “OFF” position,switch the appliance off at
the power outlet and remove the power cord from the outlet.
13. Remove the Dough Hook,Beater or Whisk.
Mixing Guide
Speed
Setting
Purpose Attachment Type of Mixture
1-3 Kneading Dough hook
• Recipes that call for LOW speed
• Pizza & Pasta
Dough, Bread
Dough, Scones
3-4 Light Mixer
Flex Edge
Beater
Beater
• Recipes that call for MEDIUM speed
• Cake & Biscuit
• Butter & Sugar
• Egg
• Icing
5-6 Aerating&Whisking Whisk • Egg Whites & Cream
Pulse
Quick bursts of
power
Whisk
• Mixtures that require short bursts of power(e.g. for
mixing under sponge, egg white)
NOTE:Short operation time: With heavy mixtures, do not operate the machine for more
than six minutes, and then allow it to cool down for a further ten minutes.
NOTE:Always begin mixing at a low speed,then increase to a high speed to prevent
splattering.
How to use the Meat Grinder
Warning:When using the Meat Grinder,Sausage-making accessory and Kebbe accessory,please
make sure to put the Back Cover on the housing.If not,it will not work because there is a security
system.It would prevent the operation.
1. Ensure the Speed Control Dial is set to the “OFF” position.
2. Insert the Screw Conveyor in the Meat Grinder Compartment with the short shaft pointing outwards
and mount the knife
onto the shaft of the screw conveyor.When monting the knife,be careful to
position the knife correctly,i.e. the flat side of the knife facing outwards towards the grinder
plate.Next,mount the grinder plate you want on the screw conveyor – take care that the notch of the
ginder plate is positioned correctly opposite the corresponding groove in the meat grinder
compartment.Finally,mount the assembly ring at the end of
the meat grinder compartment. Pls refer to
below “illustration A”.