User manual

FCC compliance
statement
This equipment has been tested and found to comply with the limits
Communications Committee) rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency
energy, and,
if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user
is encouraged to try correcting the inter-
ference by one or more of the following measures:
for a Class
B digital device, pursuant to Part I5 of the FCC (Federal
~
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
Use shielded cables to connect this device to computers.
Consult the dealer or an experienced radiom technician for help.
You may find helpful the following booklet, prepared by the FCC:
Interference Handbook This booklet
is available from the U.S. Government
Printing Office, Superintendent of Documents, Washington, DC 20402-
which the receiver
is connected.
9325; [phone].
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
Copyright
01 99 1-95 Costar Corporation. All rights reserved.
Trademarks
Labelwriter is a trademark of Costar Corporation. All other trademarks
are trademarks of their respective holders.