User manual

Type the correct drive and add the i386 path. For example, if you
installed from a CD-ROM, the drive and path will probably
be:D:\i386\
Click
OK when finished.
9. In the Description window, type a description of the printer if
you wish.
IO. In the Print to: window, select the port where it is physically
attached. This will probably be a COM port.
I I. If you wish to allow others on your network to use the print-
er, check 'Share Printer on Network'
Type the name of the printer which will appear on the other com-
puters.Type
the location of the printer for extra information.
12. Click the Settings button.
If the port you selected was
a COM port, click Settings: verify:
The setting should be set as follows:
I9200 baud
8 data bits
no parity
I stop bit
Xon/Xoff flow control.
Note: you can also use Hardware flow
control.
-~
~ ~~ ~~~ ~~~~ ~~~ ~~ ~~
13. Click the Advanced button.
Unless you are well-versed with the changes Windows NT will
make to your system, we
DO NOT RECOMMEND changing the
COM window, the BASE window, or the
IRQ window. We DO
recommend that you have FIFO disabled (unchecked). Click OK
when finished.
14. Click OK to close the Port Settings window.
I5.Click Close to close the Settings window.
I6.Click
OK to close the Create Printer window.
I -/.Click OK to close the Printer Setup window.
After you have added the print driver, you can verify or modify
settings by highlighting the printer in the Print Manager (in the
Main Group), and selecting 'Properties' from the Printer menu.
To create a custom form, follow instructions in the CUSTOM-
NT.TXT file.