User manual

Click on Connect.
In the Ports section
of the screen click on COM I, COM2, COM3
or COM4, depending on which port you are connected to. Also
hand corner of the screen.
click on the Fast Printing Direct
to Port button in the lower left
~ ~~ ~~
Costar Labelwriter XL
- Ports:
LPTZ. Local Port
Not Present
LPT3. Local Port
Not Present
: Localport
Timeouts (seconds)
Device Not Sclected
1 Transmission Retry: El
[XI East Printing Direct to port
Then click on the Settings button. Make sure the settings are set
as
follows:
Baud rate: 19200
Data Bits:
8
Parity: None
Stop Bits:
I
Flow Control: XON/XOFF
I Baud Rate:
1192001
- Data Bits:
- Parily:
- Stop Bits:
- Flow Control:
Xon f Xoff
Then Click on OK, OK, and CLOSE to exit to the control panel.
Your Labelwriter has been installed.