User manual
Exterior
maintenance
~~
~-
~~~~
~ ~~ ~ ~~ ~~~
Cleaning the outside of your Labelwriter
is
as important as clean-
ing the inside. Dusting the outside of the printer occasionally
will
reduce the incidence of foreign matter getting inside the printer.
Follow
these steps to perform exterior maintenance on your
printer:
I.
Turn
the printer
off
and disconnect the power cord.
2.
Dirt,
dust, ink and
so
on
will
more than likely be attracted
to
the exterior of your printer. Use the lint-free cloth
to
wipe the
exterior of the printer. Remove dirt and ink smudges with either
isopropyl alcohol, diluted dishwashing detergent or diluted glass
cleaner.
Avoid
products containing ammonia for cleaning the printer
or
plastic cover.
3.
Take a minute
to
clean the
work
area around the Labelwriter.
There are probably a few labels (new and used) laying around!
4.
Reconnect the power cord and turn the printer on.
Interior
maintenance
The printer’s top cover will keep out most of the
dust
and dirt
which accumulates in operating areas. However,
it
is
still
a good
idea
to
periodically perform some basic interior maintenance:
I.
Turn the printer
off
and disconnect the power cord.
2.
Open the top cover.
3.
Use a
soft
brush
or
a small,
soft
paint brush to whisk paper
dust and other stray particles away from the inside of the printer.
Remove the roll
of
labels
to
clean under the
roll,
then replace the
labels.
4.
Close the top cover.
5.
Reconnect the power cord and turn the printer on.