User manual

Figure 1-7. After the labels have been properly fed past the label tear bar,
rest the label spindle holder and close the cover.
9. Tear off the labels coming out the front of the printer by grasp-
ing the very end and pulling downward and sideways across the
edge
of the label tear bar.
IO. Close the cover and your Labelwriter printer is ready to go!
Removing an
empty label roll
When the printer runs out of labels, the power light will flash and
you
will need to remove the used roll. Follow these instructions
to remove a used roll
of label$.
I. Leave the printer turned on. Open the cover. Depending
on the label size you are using, the last label on the
roll may be
connected
to the corrugated core by a piece of tape. If it is, use
scissors
to cut the label between the roll and the label feed slot.
2. Press the Form Feed button on the printer’s front panel and
hold
it in as the printer ejects the remaining labels or backing.
3. When the labels or backing stop, pull gently to remove the
material from the printer.
Now you can load a new roll of labels.
See the Loading Labels section earlier in this chapter for instruc-
tions on how to load labels.