User manual

Loading labels
Labels are quickly and easily loaded into the Labelwriter printer.
Follow the instructions below while referring to Figures
1-5 and
1-6.
I. Open the cover so that you have access to the interior of the
printer. Remove any packing material.
2. Remove the label spindle by lifting it straight up from the label
spindle holder.
w/
For wider label rolls
I
I
) 1 GI;; a straight
Figure 1-5. Looding labels onto the label spindle.
3. Locate your roll of labels and remove the tape from the end of
the roll. Cut the lead label in half to create a nice straight edge.
The Labelwriter grabs a straight edge much easier.
4. Refer to Figure 1-5 while following these instructions: For nar-
row labels, remove the right half of the label spindle and put the
labels on the label spindle
so that the end feeds from the bottom
of the roll. Reconnect the right half of the spindle, with the label
roll snugly secured between the circular plates of the spindle.
If you're using wide labels, remove the right half
of the label
spindle and turn
it around, so that the long end of the spindle is
on the inside. An illustration indicating how to position the spindle
is molded into the black plastic base inside the printer. Put the
labels on the label spindle
so that the end feeds from the bottom
of the roll. Reconnect the right half of the spindle, with the label
roll snugly secured between the circular plates of the spindle.