User`s manual

Web Admin User’s Manual
45 Costar Video Systems, LLC
• Default Video Format (FW-3170 only): Select the video transmission format of the camera
attached to Costar Video Server. Select one from NTSC or PAL.
• Video with UART sensor Data: If Enabled, video data will contain UART sensor data from
COM port.
• Video with user defined message: If Enabled, video data will contain the user-defined data.
(Reserved Field)
• Video with PPP status: If Enabled, video data will contain PPP connection status.
• Video with camera name: If Enabled, video data will contain the camera name.
• Video with server name: If Enabled, video data will contain the server name that you
defined.
• Video with IP address: If Enabled, video data will contain the IP address of the video server.
• Audio: Select if Audio function is to be used (applies to Primary Stream only). Costar Video
Server provides 2-way audio streaming by combining microphone input with video data. Users
can listen to the streamed audio on PC speakers.
• Encoding Frame Rate (Per Channel): Compression speed every second. This attribute
applies to all the channels. You can control the server’s total traffic with this parameter.
• Image Size: Select the resolution of each channel’s video data.
• Encoding Standard: Select the compression method of each video, either M-JPEG or H.264.
• Watermark (MPEG-4 Only): If Enabled, video image will have water mark on it. This
attribute applies to all the channels.
Below is the table of images sizes supported in this mode.
Video Format D1 2CIF CIF QCIF
NTSC 704 x 480 704 x 240 352 x 240 176 x 112
PAL 704 x 576 704 x 288 352 x 288 176 x 144