Use and Care Manual

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user’s authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

o and on, the user is encouraged to try to correct the interference by one of the following

measures:

• Reorient or relocate the receiving antenna.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the speciﬁc operating instructions for satisfying RF

exposure compliance. To maintain compliance with FCC RF exposure compliance requirements,

please follow operation instructions as documented in this manual. This transmitter must not be

co-located or operating in conjunction with any other antenna or transmitter. This equipment

should be installed and operated with a minimum distance of 20cm between the radiator and

your body. The availability of some speciﬁc channels and/or operational frequency bands

are country dependent and are ﬁrmware programmed at the factory to match the intended

destination. The ﬁrmware setting is not accessible by the end user.