Use and Care Manual

9
USING YOUR KETTLE
Boiling Water
1. Add at least ½ cup / 118 mL of filtered
water to the kettle. Do not fill above the
“MAX” line. Wipe any water from the
outside of the kettle and the base.
2. Put the lid on the kettle and make sure
it fits securely. Place the kettle on the
power base.
3. Plug in the cord. The button lights will
blink, and the base will beep once.
4. Press (“ON / OFF”). The button will
light up.
Note: The kettle will turn o after 1
minute of inactivity.
Note:
If you take the kettle o the base
during Hold Temperature mode, the
(“HOLD TEMP”) button will blink. After
60 seconds, the kettle will turn o.
Note:
• Use filtered water for perfect pour over
brewing.
• If you start the kettle without water in it,
the kettle will turn o and controls will
be disabled. See Boil-Dry Protection
(page 11).
Note:
• You can only select 1 preset at a
time.
• If you take the kettle o the base
while heating, all buttons will
turn o, and the kettle will pause
heating. If you put the kettle back
within 60 seconds, it will resume
heating. After 60 seconds, the kettle
will turn o.
5. Press to choose a preset temperature
setting. The button will light up, and
the kettle will start heating up the water.
6. Optionally, press
(“HOLD
TEMP”) any time before the kettle is
finished heating. This will turn on
Hold Temperature mode, which will
automatically keep the kettle at the
same temperature for 60 minutes after
heating is finished. The button will stay
lit during that time.
7. When the water is at the preset
temperature, the kettle will beep 3
times and stop heating.