Use and Care Manual

8
USING YOUR GLASS KETTLE
Heating Water Boil-Dry Protection
Keep Warm Mode
Only heat water in this kettle. Use pure,
filtered water for best results.
1. Press the Lid Release Button to open
the lid.
2. Fill the kettle to the desired level. Make
sure the kettle is filled above the “MIN”
line and below the “MAX” line. Wipe
any excess water from the kettle’s body
and power base.
3. Close the lid, place the kettle onto the
power base, and plug in. [Figure 2.1]
4. Press a preset temperature button. You
can only select 1 preset at a time.
5. Press START/CANCEL. The kettle will
begin heating. Press START/CANCEL
at any time to stop heating early.
6. The kettle will automatically switch to
Keep Warm Mode once it has finished
heating the water.
• This kettle has a boil-dry safety feature.
If there is no water inside the kettle,
it will automatically turn o to avoid
damaging the heating element. Fill the
kettle with cold water and allow it to cool
before using again.
• Keep Warm Mode automatically
maintains the selected temperature for
60 minutes.
• If you select the Boil Black preset, the
kettle will hold the temperature at 200°F
as a safety feature to keep the water from
boiling for too long.
• If you take the kettle o the base during
Keep Warm Mode, all lights will turn o,
and the kettle will pause heating. If you
put the kettle back within 60 seconds, it
will resume Keep Warm Mode. After 60
seconds, the kettle will turn o.
• Keep Warm Mode can be turned on/o
while the kettle is in standby mode by
pressing and holding START/CANCEL
for 3 seconds. When Keep Warm Mode
is turned o, the START/CANCEL
indicator light will change from blue
to white. If Keep Warm Mode is o, the
kettle will automatically turn o once it
has reached the preset temperature.
Figure 2.1