Use and Care Manual
15
1. Press PREHEAT. “PREHEAT” will blink
on the display. You can also turn the
control knob to select “PREHEAT”.
2. Optionally, press TEMP/TIME and
turn the control knob to adjust the
temperature between 150°–450°F
/ 66°–232°C. The time will adjust
automatically.
3. Press to begin preheating. The
button will light up, and the display will
show “PREHEAT”.
4. The oven will stop heating and beep
several times when finished. The
temperature will be shown on the
display.
5. Select a cooking function and follow the
instructions in the appropriate section
to begin cooking.
Preheat Function (“PREHEAT”)
This function allows you to manually
preheat your oven without selecting another
cooking function.
Setting
Temperature
Automatic
Preheat Time
300°F /
149°C and below
3 min
305°–395°F /
152°–202°C
4 min
400°–430°F /
204°–221°C
5 min
435°–450°F /
224°–232°C
6 min
1. Select a cooking function by pressing
the control knob, then press PREHEAT.
2. When you start the cooking function
by pressing , preheating will start
automatically. The button will
light up, and the display will show
“PREHEAT”.
3. When preheating is finished, the oven
will beep several times and the display
will flash. This will repeat once every
minute. The button will blink
continuously until cooking is started.
4. Open the oven door to place food
inside, then close the oven door to start
cooking automatically. You can also
press or press the control knob to
begin cooking if the food is already in
the oven. The button will light up,
and the display will show the timer
counting down.
Air Fry, Bake, Roast, Broil, and Pizza all
use associated preheat, which means you
can preheat your oven after selecting and
starting these cooking functions. You can
also use the manual Preheat function before
selecting any cooking function.
Associated Preheat
Preheat Times
• Preheating times adjust
automatically based on the
temperature setting (see Preheat
Times chart).
• After 10 minutes of inactivity, the
cooking function will cancel, the
oven will stop heating, and the
display will reset.