User's Manual

15
1. Press PREHEAT. “PREHEAT” will blink
on the display. You can also turn the
control knob to select “PREHEAT”.
2. Optionally, turn the control knob
to adjust the temperature between
150°–450°F / 66°–232°C. The time will
adjust automatically.
1. When you start a cooking function
by pressing , preheating will start
automatically. The button will light up,
and the display will show “PREHEAT”
2. When preheating is finished, the oven
will beep several times and the display
will flash. This will repeat once every
minute. The button will blink
continuously until cooking is started
begins pressed again.
3. Open the oven door to place food
inside, then close the oven door to start
cooking automatically. You can also
press or press the control knob to
begin cooking if the food is already
in the oven. The button will light
up, and the display will show the timer
counting down.
3. Press to begin preheating. The
button will light up, and the display will
show “PREHEAT”.
4. The oven will stop heating and beep
several times when finished. The
temperature will be shown on the
display.
5. Select a cooking function and follow the
instructions in the appropriate section
to begin cooking.
Preheat Function (“PREHEAT”)
This function allows you to manually preheat
your oven without selecting another preset.
Air Fry, Bake, Pizza, Roast, and Broil all use
automatic preheat. You can also use the manual
Preheat function for any cooking function (see
page 12).
Note: You can add automatic preheat to any preset
(see Customizing Cooking Functions, page 11).
Setting
Temperature
Automatic
Preheat Time
300°F /
149°C and below
3 min
305°–395°F /
152°–202°C
4 min
400°–430°F /
204°–221°C
5 min
435°–450°F /
224°–232°C
6 min
Automatic Preheat
• Pressing again during
preheating will cancel preheating
and immediately start cooking.
• Preheating times adjust
automatically based on the
temperature setting (see Preheat
Times chart, page 15).
• After 10 minutes of inactivity, the
cooking function will cancel, the
oven will stop heating, and the
display will reset.