Instruction manual

19
P/N 62617168. Split vent kit. This kit is for
take the air from the room where the heater
is installed, and discharge the flue outside
from the building. The pipe of discharge is
length 2.5ft.. If you need extensiones or
elbows or other accessories, refer to figures
R, S and T. This kit can be used for heaters
model BMS and BTS.
P/N 62617174. Coaxial Vent & Elbow Kit.
This kit is for taking and discharging air from/
to the outside of the building. The pipe of
discharge length is 3ft. If you need extensions,
elbows or other accessories, refer to figures
O, P and Q. This kit can be used for heaters
model BM and BTS. To discharge the flue in
vertical position you must to use a roof vent
terminal 62617070, (see figure P)
P/N 62617175. Coaxial Vent & Straight
Adapter Kit. This kit is for taking and
discharging air from/to the outside of the
building. The pipe of discharge length is 3ft.
If you need extensions, elbows or other
accessories, refer to figures O, P and Q. This
kit can be used for heaters model BM and
BTS. To discharge the flue in vertical position
you must to use a roof vent terminal
62617070, (see figure P)
P/N 62630046. Vent Adaptor for 3"
Discharge pipe. This kit is for to connect only
the flue discharge to a commercial 3 pipe.
This kit must be used toghether with a heater
mounted adapter P/N 62617124 or
62617060. With this configuration, the
installer is responsible for the materials used
and for the installation. In any case follow
the national or local codes..
A INSTALLATION INSTRUCTIONS