Instruction manual

15
A INSTALLATION INSTRUCTIONS
Figure 6A - Installation of the electrical
supply cable on the model BMS
a) Remove or loosen screw (2)
b) Pop- out the passage tunnel for the
supply cable. Pass the supply cable
through the passage (1)
c) Connect the supply cable to the
junction box
d) Tighten screw (2);
e) Re-insert the passage tunnel into its
position (4).
f) Feed wire to junction box and
connect as shown in Figure 6.
Figure 6B - Installation of the
electrical supply cable on the model
BTS
a) Remove or loosen screw (2)
b) Pop- out the passage tunnel for the
supply cable. Pass the supply cable
through the passage (1)
c) Connect the supply cable to the
junction box
d) Tighten screw (2);
e) Re-insert the passage tunnel into its
position (4).
f) Feed wire to junction box and
connect as shown in Figure 6.