Manual and User Guide

9
GENERAL INFORMATION
1. Installation must conform with local codes or in
the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1 -Latest Edition.
2. Installation in manufactured (mobile) home:
installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24
CFR, Part 328O [formerly the Federal Standard for
Mobile Home Construction and Safety, Title 24,
HUD (Part 280)] or; when such standard is not
applicable, the Standard for Manufactured Home
Installations, ANSI/NCSBCS A225.1, or with local
codes where applicable.
3. Installation in Recreational Park Trailers:
installation must conform with state or other codes
or in the absence of such codes, with the Standard
for Recreational Park Trailers, ANSI A119.5.
4. WARNING: This appliance shall not be used
for space heating. This information is based on
safety considerations.
5. All openings in the wall behind the appliance and
in the floor under the appliance shall be sealed.
6. Keep appliance area clear and free from
combustible materials, gasoline. and other
flammable vapors.
7. Do not obstruct the flow of combustion and
ventilation air.
8. Disconnect the electrical supply to the appliance
before servicing.
9. When removing appliance for cleaning and/or
service;
A. Shut off gas at main supply.
B. Disconnect AC power supply.
C. Disconnect gas line to the inlet pipe.
D. Carefully lift appliance out of cabinet cutout.
CAUTION: Use care in handling.
10. Electrical Requirement
Electrical installation should comply with national
and local codes.
11.Air Supply and Ventilation
The installer must refer to local/national codes
12.Gas Manifold Pressure
Natural gas - 5" W.C.P.
LP/Propane - 10" W.C.P.
WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
The cooktops must be electrically grounded in
accordance with local codes or in the absence of
local codes, with the National Electrical
Code,ANSI/NFPA No. 70- latest edition.
Installation should be made by a licensed
electrician.
This appliance is equipped with a three-prong
grounding plug for your protection against shock
hazard and should be plugged directly into a
properly grounded socket. Do not cut or remove the
grounding prong from the plug.
For personal safety, this appliance must be properly
grounded.
Do not under any circumstances cut or remove the
third (ground) prong from the power plug.
REPLACEMENT PARTS
Only authorized replacement parts may be used in
performing service on the cooktops.