Use and Care Manual

6. Drill a 6 - 1/4” Round Hole into the bottom of the cabinet. Drill a 1 - 1/2” hole into the bottom

of the cabinet for the Electrical Access hole.

See Page 5 for hole location according to the diagram (Top View).

6a. Pull the round duct & power cord through the bottom of the

cabinet holes.

7. Lift the hood and hang the hood unit on the back wall using the screws drilled in Step 3.

the

hood.

9. Drill each of the five pieces of 5x16 wood screws (

Part C) into the bottom of the cabinet

10. Once the hood is secured into the cabinet

tighten the wood screws located in the back

of the hood.

Baffle filters back into place. Make sure hood is secure by pressing

on it. Plug unit into power outlet.

Step 7

Step 8-9

Step 6

ELECTRICAL

ACCESS HOLE