Owner Manual

B. CHANGE BURNER NOZZLES

INSTALLATION

TIP: First remove all nozzles and then start replacing them. This will help to prevent

the possibility that some may not be replaced.

1) Remove the burner g

rates, burner caps and burner heads.

2) Using a 7mm nut driver, remove the burner nozzles.

LIQUID PRETROLEUM (LP) GAS NOZZLES

BURNER POSITION NOZZLE

DIAMETER

MINIMUM

PRESSURE

MAXIMUM

PRESSURE

Auxiliary Front Right 1 x 0.70 10” 14”

Semi-Rapid Rear Left & Right 1 x 0.80 10” 14”

Rapid Front Left 1 x 0.89 10” 14”

Triple Ring Center 5 x 0.56 14”

IMPORTANT: Carefully read and observe each nozzle label for correct location.

3) Install the proper nozzles in the exact locations as noted in the illustrations above and the

table below. (See Figures 20, 21 and table above)

4) Replace the burner bases, heads, caps and top grates. Make sure burner caps are properly

seated on the burner head.

Figure 20

TRIPLE RING BURNER

5 NOZZLES

AUXILARY BURNER

SEMI-RAPID BURNER

RAPID BURNER

1 NOZZLE EACH

NOZZLES

Figure 21

10”