Owners Manual

INSTALLATION INSTRUCTIONS

GAS CONNECTIONS (All Units) (Continued)

The installation of cooktops designed for recreational vehicle installation must

conform with state or other codes or, in the absence of such codes, with the

standard for recreational vehicles. ANSI A119.2.2–1982 in the U.S.A. or CAN/CGA

Z240.4.2 in Canada.

The installation of appliances designed for recreational park trailers must conform with

state or other codes or, in the absence of such codes, with the standard for recreational

park trailers, ANSI A119.5.

NOTE: Check all piping connections in the unit for leaks. Never use an open flame to check

for gas leaks. Use a soap solution, 75% water, 25% dishwashing soap. It is possible for

connections made at the factory to leak, due to vibration encountered in transportation.

Make certain you have checked them all, and repair any connections that leak.

The appliance and its individual shut-off valve must be disconnected from the gas supply

piping system during any pressure testing of that system at test pressures in excess of 1/2

PSIG. The appliance must be isolated from the gas supply piping system by closing its

individual manual shut-off valve during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 PSIG.

GAS LINE SHUT-OFF VALVE

• To reduce the possibility of gas leaks, apply Teflon tape or a thread compound approved

for use with LP or Natural gases to all threaded connections.

• Install a manual gas line shut-off valve in the gas line in an easily accessed location

outside the range in the gas piping external to the appliance for the purpose of turning on

or shutting off gas to the appliance.

• Install male 1/2’’(30 or 36-inch cooktop) or 3/4” (48-inch cooktop) flare union adapter to 1/

2” or 3/4’’ NPT internal thread elbow at the inlet of the regulator. Use a wrench on the

regulator fitting to avoid damage.

• Install male 1/2” or 3/4” flare union adapter to the NPT internal thread of the manual

shut-off valve, taking care to secure the shut-off valve to keep it from turning.

• Check for leaks using a leak detector or soapy water, 75% water, 25% dishwashing soap.

(Continued on next page)