Owners Manual

CARE & MAINTENANCE

GREASING THE VALVES

If it becomes difficult to operate the valve, it should be greased immediately by following

the steps below:

1.) Disassemble the valve body by loosening the two screws located on the body of the

valve.

2.) Extract and clean the seal cone and its housing with a rag soaked with thinners.

3.) Lightly grease the cone with special grease.

4.) Insert the cone, moving it several times, remove it again, remove the excess grease

and make sure that the gas passageways are unobstructed.

5.) Replace all the pieces in reverse order and check that the valve operates correctly.