User Manual

If the low ame needs to be adjusted:
MAX
MIN
OFF
a
b
a Adjustment Screw
b Control Knob Stem
1. Light one burner and turn the control knob to the lowest setting.
2. Remove the control knob.
3. Insert a small, at-blade screwdriver into the adjustment screw, and slowly turn
the screw until the ame appearance is correct.
•
Open the valve more if the ames are too small or uttered.
•
Close the valve more if the ames are too large.
4. Replace the control knob.
5. Test the ame by turning the control from “LO” to “HI,” checking the ame at
each setting.
6. Repeat above steps for each burner.
GAS CONVERSION
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure
does not exceed 14" (36 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion or fire.
28