Installation Manual

Power Supply Location

IMPORTANT: An electrical outlet in the floor, may be either recessed or

surface mounted, but an electrical outlet in the wall must be recessed to make

the connection. For Direct Wiring, the electrical box should be mounted to the

wall.

VENTING REQUIREMENTS

IMPORTANT: This range must be exhausted outdoors unless you are using

ductless venting. Observe all governing codes and ordinances. Do not

obstruct flow of combustion and ventilation air.

• Do not terminate the vent system in an attic or other enclosed area.

• Use an approved vent cap for proper performance. If an alternate wall or

roof cap is used, be certain the cap size is not reduced and that it has a

backdraft damper.

• Vent system must terminate to the outside unless you are using a ductless

vent kit.

• Rigid metal vent is recommended. For best performance, do not use plastic

or metal foil vent.

• If a joist or stud must be cut, then a supporting frame must be constructed.

• The size of the vent should be uniform.

• The vent system must have a damper.

• Seal all joints in the vent system.

• Use caulking to seal exterior wall or roof opening around the cap.

• Determine which venting method is best for your application.

30" (76 cm)

11½" (29.2 cm)

6" (15.2 cm)

7¼" (18.4 cm)

3" (7.6 cm)

17½" (44 cm)

Recommended Location for

Electrical Outlet

Recommended Location for

Gas Supply Connection