User Manual

12 13
2- INSTALL PRESSURE REGULATOR
A. Screw the regulator onto the burner box bottom pipe connection. Make
sure the top of the regulator is facing toward the cabinet front and the arrow
on the back of the regulator points to the cooktop.
B. Complete the connection between the regulator and the shut-off valve.
C. Before testing for leaks, make sure all burner knobs are in the OFF position.
After connecting the cooktop to gas, check system for leaks with a manom-
eter. If a manometer is not available, turn the gas supply on to the cooktop
and use a liquid leak detector at all joints and connections to check for leaks.
Tighten all connections if necessary to prevent gas leakage in the cooktop or
supply line.
D. Gently insert the cooktop right side up centered into the cutout opening.
Make sure the front edge of the countertop is parallel to the cooktop. Check
clearances at the front, back, and sides.
E. Secure the cooktop from underneath with the mounting brackets and
screws supplied.
F. Install the cooktop burners and caps, then gently place the surface grates on
the cooktop.
FRONT
Gas Inlet
INSTALLATION INSTRUCTIONS
1- INSTALLING THE COOKTOP
A. Unpack the cooktop without installing the cooktop burners and surface
grates, and gently lay it upside down on a towel or tablecloth covered
countertop.
B. Locate electrical outlet and gas shut-off valve beneath cabinet.
C. Apply the foam gasket tape around the bottom edge of the cooktop.
Foam Gasket
A- Manifold Entrance
B- Pressure Regulator
C- Flare Union Adapter
D- Flexible Connector
E- Flare Union Adapter
F- Manual Gas Shutoff Valve
D
A
C
E
F
B
No Obstructions Below Cooktop
Gas flow into cooktop