Installation Guide

12 13
INSTALLATION INSTRUCTIONS
CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE
ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.
1. Drill two 8mm holes in position for plastic wall anchor (Part B) placement.
(See above for placement location).
2.
Tap plastic wall anchors securely into each of the drilled holes.
3.
After Wall anchors have been tapped in place, Insert ST4*40 wood screws (part D), but
leave 1/4” of the screw sticking out of the wall. (This will give your Range Hood
something to hang onto).
B
30” Model:
A= 25.6”
B = 1 - 1/8"
A
CABINET
If using recirculating mode: skip steps 4, 5a,
5c, 6a, 6c.
If cabinet bottom is recessed, we recommend installing wooden shims on cabinet bottom to make
cabinet mounting area flush.
INSTALLATION INSTRUCTIONS
5. 5a. If mounting to the wall only, drill a 5.25” round hole on the back wall above the hood, OR
into the ceiling directly above the hood, or on the back wall centered with the rear vent hole of the
hood. (Skip this step for recirculating mode)
5b. Lift the hood and hang the hood unit on the back wall using the screws drilled in Step 3.
Once the hood is securely hung on the wall, tighten the screws from the interior of the hood
after removing the aluminum filters.
5c. Pull rectangular adapter / ductwork through the newly drilled hole in the wall. Connect unit to
power source. (Skip this step for recirculating mode)
Step 5b.
If mounting to a cabinet, skip step 5.
4. Take the hood unit along with the 5” Round Aluminum duct (Top) -OR-
rectangular adapter / ductwork (Back). Secure the round aluminum duct to
the damper at the top or rear of the hood unit using HVAC Aluminum foil
tape. (Skip this step for recirculating mode)