Installation Manual

35
To adjust standard burner:
The ame can be adjusted using the adjustment screw in the center of the valve
stem. The valve stem is located directly behind the control knob.
If the low ame needs to be adjusted:
MAX
MIN
OFF
a
b
a Adjustment Screw
b Control Knob Stem
1. Light one burner and turn the control knob to the lowest setting.
2. Remove the control knob.
3. Insert a small, at-blade screwdriver into the adjustment screw, and slowly turn
the screw until the ame appearance is correct.
•
Open the valve more if the ames are too small or uttered.
•
Close the valve more if the ames are too large.
4. Replace the control knob.
5. Test the ame by turning the control from “LO” to “HI,” checking the ame at
each setting.
6. Repeat these steps for each burner.