Installation Manual

25
CONVERT TO LP GAS (OPTIONAL)
This range is shipped from the factory set up to use natural gas. It can be
converted to use LP gas by a qualified service technician.
The LP conversion kit is sold separately. The conversion to LP requires all
surface burner orifices and, if applicable, gas oven orifices to be changed. In
addition, the nozzle on the gas pressure regulator needs to be reversed.
See "GAS CONVERSION" section for detailed instructions.
NOTE: All replaced orifices must be left with the consumer, including the
instructions and retrofit sizes and orifice indication.
COMPLETE INSTALLATION
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Plug into a grounded 3-prong outlet.
Do not use an adapter or an extension cord.
Failure to do so can result in death, fire, or electrical shock
1. Open the manual shutoff valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
2. Test all connections by brushing on an approved noncorrosive leak-
detection solution. If bubbles appear, a leak is indicated. Correct any leak
found.