Installation Manual

23
GAS CONNECTION GAS CONNECTION
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line and install a shut-
off valve for new installations.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does
not exceed the maximum pressure listed in the "Gas Supply Requirement"
section.
Examples of a qualified person include:
• licensed heating personnel
• authorized gas company personnel
• authorized service personnel
Failure to do so can result in death, explosion or fire.
This appliance shall be installed only by authorized persons and in
accordance with the manufacturer's installation instructions, local gas fitting
regulations, municipal building codes, electrical wiring regulations, local
water supply regulations. The agency performing this work assumes
responsibility for the quality of work performed, including checking for leaks
and ensuring installation meets code requirements.
This range is factory-set for use with Natural gas. To use this range with
Propane gas, see the "GAS CONVERSION" section before connecting this
range to the gas supply. Gas conversions from Natural gas to Propane gas or
from Propane gas to Natural gas must be done by a qualified installer.
TYPICAL FLEXIBLE CONNECTION
1. Apply pipe-joint compound made for use with LP gas to the smaller
thread ends of the flexible connector adapters.