Installation Guide
Read all instructions before using this appliance.
Save these instructions for future references
Approved for residential appliances. For residential use only .
Due to the weight and size of these vent hoods and to reduce the risk of personal injury or damage to the product, 
TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION.
IMPORTANT 
SAFETY INSTRUCTIONS
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT USE 
TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS 
OR VAPORS.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
GROUNDING INSTRUCTIONS
This 
appliance  must  be  grounded.  In  the  event  of  an  electrical 
short circuit,  grounding  reduces the  risk of  electric shock  by 
providing an  escape wire  for the  electric current.  This appliance 
is equipped with a cord having a grounding wire with a grounding 
plug.  The  plug  must  be  plugged  into  an  outlet  that  is  properly 
installed and grounded.
WARNING - IMPROPER GROUNDING CAN 
RESULT IN A RISK OF ELECTRIC SHOCK.
Consult a qualified electrician if the grounding instructions are 
not completely understood, or if doubt exists as to whether the 
appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too 
short, have a qualified electrician install an outlet near the 
appliance.
CAUTION
To reduce risk of fire and to properly exhaust air, do not 
vent exhaust air into spaces within walls, ceilings, attics, 
crawl spaces, or garages. 
WARNING
TO REDUCE THE RISK OF FIRE, USE ONLY METAL 
DUCT WORK. Install this hood in accordance with all 
requirements specified.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO 
PERSONS, OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the 
manufacturer. If you have questions, contact the 
 manufacturer
B. Before servicing or cleaning the unit, switch power 
off at service panel and lock service panel 
disconnecting means to prevent 
power from 
being switched on accidentally. When the service disconnecting means 
cannot be locked, securely fasten a prominent warning device, such as a 
tag, to the service panel.
C. Installation Work and Electrical Wiring Must Be Done 
By Qualied Person(s) In Accordance With all Aplicable Codes & 
Standards, Including Fire-rated Construction.
exhausting of gases through the ue (Chimney) of fuel burning equipment to 
prevent back- drafting. Follolow the heating equipment manufacturers 
guideline and safety standards such as those published by the National Fire 
Protection Association (NFPA), the American Society for Heating, 
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code 
authorities.
When cutting or drilling into wall or ceiling, do not 
damage electrical wiring and other hidden utilities. 
Ducted systems must always be vented to the outdoors.
A.
E.
F.
D. Sufcient air is needed for proper combustion and 
WARNING
To 
Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Hood 
With Any External Solid State Speed Control Device.
WARNING
WARNING
Unplug or disconnect the appliance 
from the power supply 
before servicing.
TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
A. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then
turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go
out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN – You may be burned.
C. DO NOT USE WATER, including wet dishcloths or towels – a violent steam ex-
plosion will result.
D. Use an extinguisher ONLY if:
1
) You know you have a Class ABC extinguisher, and you already know how to
operate it.
2
) The fire is small and contained in the area where it started.
3) The fire department is being called.
4) You can fight the fire with your back to an exit.
Always leave safety grills and filters in place.Without these components, 
operating blowers could catch onto hair, fingers and loose clothing.
The manufacturer declines all responsibility in the event of failure to observe 
the instructions given here for installation,maintenance and suitable use of the 
product. The manufacturer further declines all responsability for injury due to 
negligence and the warranty of the unit automatically expires due to improper 
maintenance.
WARNING
WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
A. 
Never  leave  surface  units  unattended  at  high  settings.  Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils slowly
on low or medium settings.
B. Always turn hood ON when cooking at high heat or when flaming food
(i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe).
C. Clean ventilating fans frequently. Grease should not be allowed to ac-
cumulate on fan or filter.
D. Use proper pan size. Always use cookware appropriate for the size of
the surface element.
2










