Installation Guide

Step 3:

Connect installed duct to existing ductwork.

For best performance avoid steep angles in

duct work.

Step 4:

A. Install the Drip Tray inside the bottom

rear of the range hood.

B. Install the baffle filters by inserting at an

angle towards the rear of the range hood.

Push the filter up and insert front of filter

into front recess. Slightly lower the filter

then slide back until it is in proper position.

Rear Mounted Installation

A. Find the key holes in the back of the range hood.

Mark their locations at the installation location with a

pencil or marker.

B. Drill 5/16"

(8mm) hole at each of the marked

locations.

C. Insert anchors into each drilled hole. Firmly

screw them into place.

D. Hang your Range Hood into place by aligning the

anchors with the key holes in the back of the range

hood.

Larger images on Pages 4,5,6