Installation Guide

This appliance shall only be installed by an authorized person.
This appliance shall be installed in accordance with the manufacturers
installation instructions,
IMPORTANT: this appliance must be installed in accordance with the
norms in force of the country concerned.
The installation of this appliance must conform to local codes and
ordinances. In the absence of local codes, Installations must conforms
to American National Standards, National Fuel Gas Code
ANSI Z223.1 – latest edition** or B149.1.
If local codes permit, a flexible metal appliance connection with the
new AGA or CGA certified design, max. 5 feet (1,5 m) long, 1⁄2” I.D.
recommended for connecting this cooktop to the gas supply line.
Do not bend or damage the flexible connector when moving the
cooktop. The pressure regulator has 1⁄2” female pipe thread.
You will need to determine the fitting required, depending on the
size of your gas supply line, the flexible metal connector and the
shutoff valve.
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70.
The appliance and its individual shutoff valve must be disconnected
from the gas supply piping system any pressure testing of that system
at test pressure in excess of 1⁄2 psi (3,5 kPa).
The appliance must be isolated from the gas supply piping system by
closing its individual manual shutoff valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than
1⁄2 psi (3.5 kPa).
For use with a pressure regulator. The regulator supplied must be
used with this appliance.
The gas appliance pressure regulator must be set for the gas with
which the appliance is used.
INSTALLATION GUIDE
4