Installation Guide

12
NOTE:
• Remove tape and any temporary labels from your refrigerator before
using. Do not remove any warning labels, the model and serial number
label, or the rating label.
• To remove any remaining tape or glue, rub the area briskly with your
thumb. Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage
the surface of your refrigerator.
• Reinstall or adjust shelves as needed. Refrigerator shelves are installed
in the shipping position. Reinstall shelves according to your individual
storage needs.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
If the refrigerator has an icemaker, it will have to be connected to a cold
water line.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will go below 60°F
(16°C) because it will not run often enough to maintain proper
temperatures.
• Do not install the refrigerator where the temperature will go above 100°F
(37°C) because it will not perform properly.
• Do not install the refrigerator in a location exposed to water (rain, etc.) or
direct sunlight.
• Install it on a floor strong enough to support it fully loaded.