Installation Guide
35
CHECKING OPERATION OF THE SURFACE HEATING
ELEMENTS
STANDARD SURFACE HEATING ELEMENTS
• Turn each knob to the "Hi" position to check that the surface heating
elements are working properly.
The elements should glow red and radiate heat, and they should cycle on
and off periodically even when the knob is in the "Hi" position.
DUAL SURFACE HEATING ELEMENT
• Turn each knob to each marking position to check that the surface
heating elements are working properly.
- Single-ring: only the smaller inner heating element is powered.
- Double-ring: both inner and outer heating elements are powered.
The elements should glow red and radiate heat, and they should cycle on
and off periodically.
SURFACE WARMING ZONE
• Press WARM ZONE on the oven control panel to turn warming zone
On/Off, and check that the warming zone heating element is working
properly. "WARMING ZONE" will be shown in the display.
The element will not glow and will need to be operated for several
minutes before noticeable heat will be produced.
Warming
zone