Installation Guide

2. Insert the bare neutral (white) wire end through the lower center terminal

block opening.

3. Insert the two side bare wire ends into the lower left and the lower right

terminal block openings.

4. Tighten the 3 terminal screws securely into the terminal block, and

replace the terminal block access cover.

4-WIRE CONNECTION: CONDUIT

Use this method for:

• New branch-circuit installations (1996 NEC)

• Mobile homes / Recreational vehicles

• Areas where local codes prohibit grounding through the neutral

• The neutral wire of the supply circuit must be connected to the neutral

terminal located in the lower center of the terminal block. The power

leads must be connected to the lower left and the lower right terminals

of the terminal block. The grounding lead must be connected to the

frame of the range with the ground screw. Failure to do so can result in

electrical shock, severe personal injury or death.

WARNING

BLACK

RED

WHITE

GREEN

Remove or cut

ground strap