Installation Guide

For power cord installations

For conduit installations

• Strip outer covering back 3" (7.6 cm) to expose wires.

• Strip the insulation back 3/8" (1.0 cm) from the end of each wire.

• Insert the conduit strain relief in the 1 1/8" (2.8 cm) conduit hole. Then

install the conduit through the body of the strain relief and fasten the

strain relief with its ring. Allow enough slack to easily attach the wires

to the terminal block.

4. Complete installation following instructions for your type of electrical

connection:

• 4-wire (recommended)

• 3-wire (if 4-wire is not available)

• Hook the strain relief over the 1 3/8" (3.5 cm) power cord hole. Insert

the power cord through the strain relief and tighten it. Allow enough

slack to easily attach the cord terminals to the terminal block.