Installation Guide

2. Adjust the cord/conduit connection plate.

For power cord installations

• Leave the connection plate as installed, and use the larger 1 3/8" (3.5

cm) power cord hole.

For conduit installations

• Remove the screw from below.

• Remove and rotate the connection plate, and use the smaller 1 1/8"

(2.8 cm) conduit hole.

• Replace the screw.

3. Install the power cord or conduit.

NOTE:

• Do not install the power cord or conduit without a strain relief. The

strain relief bracket must be installed before replacing the

terminal block access cover.

Screw

1 ³⁄₈" (3.5 cm)

power cord

hole

1 ¹⁄₈" (2.8 cm)

conduit

hole