Installation Guide

For old gas ranges, shut off the gas supply valve to the range before

disconnecting the range and leave it off.

2. Move appliance to access the electrical connection and gas connection if

applicable.

3. Disconnect electrical connection and gas connection if applicable, and

move appliance out of and away from installation space.

UNPACK RANGE

EXCESSIVE WEIGHT HAZARD

• Use two or more people to move and install range. Failure to do so can

result in back or other injury.

1. Remove all tape and packaging materials. Check for film on stainless

steel parts, padding/spacers on and around door and face of oven,

cardboard and plastic on and around racks, inside storage drawer, etc.

Failure to remove packaging materials could result in damage to the

appliance.

NOTE:

• Do not remove any warning-type labels, the model and serial

number label, or the Tech Sheet that is located on the back of the

range.

• Do not use sharp instruments, rubbing alcohol, flammable fluids,

or abrasive cleaners to remove tape or glue. These products can

damage the surface of your range.

• Do not push or pull the range by grabbing the open oven door or

cooktop only. Doing so can result in serious damage to the range.

• Do not lift the range using the cooktop or oven door handle. Doing

so can cause damage and improper operation of the range.

• Do not dispose of anything until the installation is complete.

WARNING