Installation Guide

13
ELECTRICAL CONNECTION
If codes permit and a separate ground wire is used, it is recommended that a
qualified electrical installer determine that the ground path and wire gauge
are in accordance with local codes.
WARNING: Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician or service
technician if you are in doubt as to whether the appliance is properly
grounded. Do not modify the power supply cord plug. If it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it here.
• This appliance must be supplied with the proper voltage and frequency,
and connected to an individual, properly grounded, 40 amp (minimum)
branch circuit protected by a circuit breaker or time-delay fuse.
• A single-phase (split-phase), 3-wire or 4-wire, AC 120/208 Volt or 120/240
Volt 60 hertz electrical system must be used. It is the personal
responsibility of the range owner to provide the correct electrical service
for this range.
• Effective January 1, 1996, the National Electrical Code requires that new
construction (not existing) utilize a 4-conductor connection to an electric
range. When installing an electric range in new construction, mobile
home, recreational vehicle, or an area where local codes prohibit
grounding through the neutral conductor.
• This range may be connected by means of a conduit or power cord.
• A range cord rated at 40 amps with 120/240 minimum volt range is
required. If a 50 amp range cord is used, it should be marked for use with
13/8" diameter connection openings. Care should be taken to center the
cable and strain relief within the knockout hole to keep the edge from
damaging the cable.
• Use only a 3-conductor or a 4-conductor UL-listed range cord. These
cords may be provided with ring terminals on wire and a strain relief
device.
• Allow 2 to 3 ft (61.0 to 91.4 cm) of slack in the line so that the range can be
moved if servicing is ever necessary.
• A UL Listed conduit connector must be provided at each end of the power
supply cable (at the range and at the junction box).
• The power supply cord and plug should not be modified. If it will not fit
the outlet, have a proper outlet installed by a qualified electrician.