Installation Guide

INSTALLATION GUIDE
PRESSURE REGULATOR ADJUSTMENT FOR GAS CONVERSION:
The pressure regulator supplied with the appliance is a convertible
type pressure regulator for use with Natural Gas at a nominal outlet
pressure of 4” W.C. or LP gas at a nominal outlet pressure of 10” W.C.
and it is pre-arranged from the factory to operate with one of these
gas/pressure as indicated in the pre-arranging labels affixed on the
appliance, package and Instruction booklet.
Your cooktop is shipped from the factory set for use with natural gas.
It can be converted for use with propane gas by following steps
below. Note: The agency performing this work assumes responsiblity
for the conversion.
10
1)
Unscrew by hand the upper metal stopper of the regulator (Fig. 5)
2)
Unscrew by hand the white plastic piece screwed under the above
mentioned metal stopper. Afterward, screw in this part again in
opposite way under the metal stopper (for gas reference see the
written “LP” and “NAT” with relative indicating arrows on the white
piece).
3))
Screw again by hand the metal stopper in the original position on
the regulator.