Use and Care Guide

DO NOT USE EXTENSION CORDS WITH
THIS APPLIANCE AS IT MAY RESULT IN
FIRE, ELECTRIC SHOCK OR OTHER
type of PERSONAL INJURY.
The appliance is equipped at the factory with an
electric supply cord set 4 wires type with ring
terminals (L1, L2, N, Ground) suitabl e for range
use UL/CSA listed type SRDT/DRT 2x6AWG (L1,
L2)+2x8AWG (N, G) rated 300V, 40 or 50A with
fused plug type NEMA 14‐50P; cable length 1,5
m.;incasethesupplycordsetmustbereplaced,it
shall be replaced with anidentical set having the
same technical specs and following carefully the
instructionsanddiagramsbelow:
1) Disconnect appliance f rom electrical power
supplyreceptacle
2) Slideouttheappliancefrominstallationplace
toaccesstobackenclosurepanel
3) Remove back enclosure panel  by removing
the6screwsasshownbelow
4)
Loosestrainreliefbyunscrewingthetwo
strainrelief'sscrewsasindiagram.
5)
Remove damaged supply cord set by taking
off the 4 electrical connection screws (block L1,
N,L2andGroundscrew,seediagram)
6) Insert the new supply cord set in the strain
relief and lock it with two strain relief's
screwsinsuitableposition.
7) FixwelltheringterminalsG,L1,N,L2ofthe
new supply cord set asshown in diagram
withits4screws
8) Re‐install the back enclosure panel with 6
screws
9) Slide the appliance back into itsproper
location
10) Re‐connect the appliance to the electrical
power.
12
POWER CORD REPLACEMENT