Instructions / Assembly

ASSEMBLY OF THE BURNERS

The electrode of the electronic ignition system is positioned above the surface of the burner base. Do

not remove a burner cap or touch the electrode of a burner while another is turned on. Damage or

electrical shock may occur.

1. Place burner heads over the burner base.

Make sure the hole in the burner head is

properly aligned with the electrode in the

burner base. (See Figure 13)

2. Place the burner caps on the burner heads.

Make sure that the burner cap

s are

properly seated on the burner head. (See

Figure 14)

3. Operation of the electric igniters should be

tested after the range and supply line have

been carefully checked for leaks and the

range has been connected to the electrical

power. To check igniters, push and turn a

sounds), but only the burner turned to LITE

will light.

Figure 13

Figure 14