Installation Guide

3. Slowly attempt to tilt the range forward.

If you encounter immediate resistance, the range foot is engaged in the anti-tip

bracket. Go to Step 8.

4. 



foot is not engaged in the anti-tip bracket.

IMPORTANT: If there is a snapping or popping sound when lifting the range,

the range may not be fully engaged in the bracket. Check to see if there are

obstructions keeping the range from sliding to the wall or keeping the range foot

from sliding into the bracket. Verify that the bracket is held securely in place by

the mounting screws.

5. Slide the range forward, and verify that the anti-tip bracket is securely attached



6. Slide range back so the rear range foot is inserted into the slot of the anti-tip

bracket.

7. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip

bracket.



resistance, the anti-tip bracket may not be installed correctly. Do not operate

the range without anti-tip bracket installed and engaged.

8. 

to check that the range is level from side to side and front to back.

NOTE: The range must be level for optimum cooking and baking performance.

9. If needed, use a wrench to adjust the height of the leveling legs until the range is

level from side to side.

STEP 7 - LEVEL THE RANGE (IF NEEDED)

IMPORTANT: The range must be level.



1. If the range is not level, pull the range forward until rear leveling leg is disengaged

from the anti-tip bracket.

2. 

3. Place the level on the rack.

4. Using a wrench or pliers, adjust the leveling legs up or down until the range is

level.

5. Push range back into position. Check that rear leveling leg is engaged in the

anti-tip bracket.